Rf5132-433 Leds; Deleting Wireless Devices - DSC PowerSeries RF5132-433 Manuel D'installation

3. Enter programming section [61] to [68] for partitions 1 to 8.
4. For each of the 4 function buttons, enter the 2-digit number of the function you want to select. See the
programming worksheets in the back of this manual for a list of function key options.
5. Record your programming choices in the worksheets in the back of the manual.
6. To exit press [#].

3.5 RF5132-433 LEDs

The RF5132-433 v5.0 features two LEDs to help with the installation of devices and troubleshoot the operation of the
unit. In normal operation the LEDs will indicate if the signal received is from an enrolled device or not.
• The green LED will flash when receiving a signal from an enrolled device.
• The red LED will flash when receiving a signal from a non-enrolled device.
Alternatively, when the panel is in placement test mode, the green LED will only flash for the specific serial number
entered. All other signals (including signals from valid enrolled devices) will flash red.

3.6 Deleting Wireless Devices

To remove a wireless device from the system, follow the guideline for adding a wireless device. Program the ESN as
[000000]. The wireless device for the zone will be removed.
Now that you have enrolled all the wireless devices, you will need to program the system to
work properly with the devices. See section 4 for more information.
8