Genie C-160X Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
2. Securely mount the document shredder on a waste basket. In the process,
ensure that you do not catch your fingers between the top edge of the
waste basket and the shredder.
3. Connect the main plug to a standard 230-240 volt AC socket.
Starting the document shredder:
Important note:
This device is designed solely for private use in enclosed quarters and for
brief operation not exceeding 2 minutes.
shredder for commercial applications nor outdoors. Improper use poses
risk of accidents.
The main switch has 3 positions. To start the device set the button into position
"AUTO".
1.
AUTO (automatic start): the shredding operation will start automatically
once the document to be shredded is inserted in the feed slot. The document
shredder is set to normal operation. Please only insert the paper EVENLY into
the feed slot otherwise a paper jam may result. After the paper has been fed
into the shredding slot, the document shredder will deactivate automatically. If
the unit does not deactivate, check whether the waste basket is full or whether
leftover paper is located in the shredder.
If the document shredder is operating and you remove the waste basket in
order to empty it, the unit will immediately stop the shredding process.
Only insert paper into the designated feed slots!
2.
REVERSE<< (reverse operation): These two buttons make the cutting unit
turn forward or backward. With these functions paper jams can be removed
(please refer to chapter "Protection against paper jams and overloading").
3.
OFF position is recommended when emptying the wastebasket or when
the shredder is not in use for a prolonged period of time.
Capacity of the document shredder:
The C-160 X shreds up to 6 sheets of paper (DIN A4, 80g). The paper width may
comprise up to 21.8 cm. When shredding small paper sizes such as letters or credit
card receipts, please insert them into the middle of the shredding slot.
Please ensure that never more than the above-mentioned maximum quantity is
inserted in the shredder. Otherwise the device may sustain damage.
Protection against paper jams and overloading:
The C-160 X is equipped with a motor overload guard. To protect the machine well,
we suggest the user to operate it in this way: work 2 minutes then rest 60 minutes.
Under the following conditions, the current feed to the unit's motor is interrupted:
1. Continual operation of the document shredder with maximum capacity for a
prolonged period of time, e.g. longer than 2 minutes without interruption.
Do not use the document
9

Publicité

Table des Matières
loading

Table des Matières