F.Bertazzoni REF603BBNPVC Guide D'utilisation page 52

ERROR TYPE
E10
E11
If your fridge freezer is not working
properly, it may be a minor problem,
therefore check the following, before calling
an electrician to save time and money.
What to do if your appliance does not
operate;
Check that;
• There is no power,
• The general switch in your home is
disconnected,
• The socket is not sufficient. To check this,
plug in another appliance that you know
which is working into the same socket.
What to do if your appliance performs
poorly;
Check that;
• You have not overloaded the appliance,
• The fridge temperature set to MAX.
• The door is closed perfectly,
• There is no dust on the condenser,
• There is enough place at the rear and
side walls.
MEANING
Fridge compartment is
not cold enough
Fridge compartment is
too cold
WHY
Likely to occur after:
- Long term power failure.
- Hot food has been left in
the fridge.
Various
If your fridge is operating too loudly;
Normal Noises
Cracking (Ice cracking) Noise:
• During automatic defrosting.
• When the appliance is cooled or
warmed (due to expansion of appliance
material).
Short cracking: Heard when the
thermostat switches the compressor on/
off.
Compressor noise: Normal motor
noise. This noise means that the
compressor operates normally
Compressor may cause more noise for a
short time when it is activated.
Bubbling noise and splash: This noise
is caused by the flow of the refrigerant in
the tubes of the system.
Water flow noise: Normal flow noise
of water flowing to the evaporation
container during defrosting. This noise
can be heard during defrosting.
Air Blow Noise: Normal fan noise. This
noise can be heard in fridges during
normal operation of the system due to
the circulation of air.
EN - 52
WHAT TO DO
1. Set the fridge temperature to
a colder value or set Super
Cool. This should remove the
error code once the required
temperature has been reached.
Keep doors closed to improve
time taken to reach the correct
temperature.
2. Please empty the location
at the front area of air duct
channel holes and avoid
putting food close to the
sensor.
If this warning continues an
authorised technician needs to be
contacted.
1. Check is Super Cool mode is
activated
2. Reduce the fridge
compartment temperature
3. Check to see if vents are clear
and not clogged
If this warning continues an
authorised technician needs to be
contacted.