Install Cooktop, Downdraft Vent And Blower Motor Assembly - Jennair JVD0303GS Instructions D'installation

10. Install the recirculation cover to the recirculation assembly in
the cabinet kick plate.
11. Optional: The opening in the cabinet floor can be covered to
trim out the cabinet interior.
Install Cooktop, Downdraft Vent and
Blower Motor Assembly
Prepare Blower Motor Assembly
NOTE: Remove shipping support from Blower Motor.
A. Blower motor shipping support must be removed.
B. Wood block shipping support must be removed.
C. Blower Motor Housing.
D. Remove screw securing Wood Block to remove block.
Replace screw in blower housing sides after removing
wood block.
Vented
1. Secure with 3-screws and aluminum metal duct tape.
Assemble duct mounting ring to blower assembly with
3-screws. Position telescoping duct between intake
transition and blower motor (large duct to blower). Secure
ducting with sheet metal screws and use aluminum metal
tape to seal all joints.
14
A
B
C
D
NOTE: Factory blower outlet position is rear-vented.
A. Intake transition
B. Telescoping round duct
C. Blower ring
D. Blower motor
2. Prepare the blower assembly for installation and assemble
the two hold down brackets supplied on the blower.
3. Locate the downdraft vent in the countertop.
4. Assemble the supplied transition for connection to the
blower assembly using the four sheet metal screws supplied.
5. Assemble the telescoping duct, supplied to the blower
assembly. Secure all joints and seal using aluminum metal
duct tape.
6. Use wood screws to secure the blower to the cabinet floor
using the two blower hold down brackets supplied. Secure
one at the front and one at the rear.
A
B
C
D