Sony DSRM-E1 Mode D'emploi page 28

Editing
24 EN
5
Using the jog dial and shuttle
ring, position the tape at the
end of the cut, and press the
MARK OUT button.
This sets the OUT point, and
displays the time on the
screen.
When both the IN and OUT
points are set, the cut number
is automatically incremented.
Note
With this unit, performance
cannot be guaranteed if the
duration of a single cut is
below 1 second.
6
Repeat steps 4 and 5 as
required to create a number of
cuts.
Numbers are allocated to the
cuts in the order of their
creation.
7
When you have finished
creating cuts, press the STOP
button to stop the tape.