Minox DTC 390 Mode D'emploi page 23

In the photo + video mode, the camera first takes a
predetermined number of photos and then a video is
recorded. Select the desired setting and push OK.
b) PIR Interval: From 2 seconds to 60 minutes: Select
the amount of time the camera should wait before the
camera should trigger again after a photo or video has
just been made. This function can prevent repeated and
undesired recordings of the same occurrence. Select the
desired setting and push OK.
c) PIR Level: Set the sensitivity of the infrared sensors
here (they react to the difference between the sur-
rounding temperature and the temperature of animals
or persons moving within the sensor detection zone). In
normal situations, it is recommended to use the "Mid-
dle" setting. In summer, where body temperatures are
about the same as the surrounding temperature, it is
recommended to use the "High" setting. Select the de-
sired setting and push OK.
d) Capture Num: 1, 2 or 3 photos: Select the number of
photos that should be made each time the camera is
triggered and push OK. See also "PIR Interval".
e) Video Length: 10, 20 or 30 seconds, as well as 1, 2
or 5 minutes: Select the length of video that should be
recorded each time the camera is triggered and push OK.
f) Video Size: High resolution videos provide higher qual-
ity videos but use considerably more storage space. It is
recommended to use the default setting of 720p. Select
the desired setting and push OK.
g) Language: Select the desired language and push OK.
h) Set Clock: Set time and date: Use the "right" and "left"
arrow keys to select the unit that needs to be changed
and the "up" and "down" arrow buttons to select the
desired unit. Push OK to save your settings.
i) Stamp: Select "Yes" if you wish the timestamp to ap-
44
pear in your recorded images or "No" if the timestamp
should not appear and push OK.
j) Photo Size: Select photo resolution: It is recommended
to set your camera to "5M". Photos with higher reso-
lutions use considerably more storage space. Select the
desired setting and push OK.
k) Software: Choose from two options: Select "FW up-
date" to update the firmware or "Version: ..." to check
the currently installed firmware version. Select the de-
sired option and push OK.
l) Audio Recording: Here you can choose whether audio
should be recorded in video mode or not. Select the de-
sired setting and push OK.
m) IR LED: Select the number of LEDs that should light up
when a photo or video is made at night. It is recom-
mended to set the number to 42 for the maximum range
and illumination. Select the desired setting and push OK.
n) Beep Sound: Here you can activate or deactivate the
beep sound of the control buttons. Select the desired
setting and push OK.
o) Side PIR: Here you can set the PIR angle of detection. To
maximise the detection angle, it is recommended to ac-
tivate the side PIRs. If the area of detection is restricted
to a minimum (e.g. hallway or similar), the side PIRs can
be deactivated to minimise unwanted recordings. Select
the desired setting and push OK.
p) Time Lapse: 15 sec., 30 sec., or 1 – 30 min.: If the Timer
Setting has been activated, the camera will record im-
ages or videos in accordance with the selected time in-
terval, regardless if the PIR sensors have been triggered
or not – e.g. growth of plants, progress at a construction
site etc. Select the desired setting and push OK.
q) Timer Setting: Here you can determine times of the day
in which the camera should be activated – surveillance
45