Network Settings - Technics SU-R1 Mode D'emploi

Network settings

You can stream music from an iOS device
(iPhone/iPad/iPod), an Android™ device or a PC
(Mac/Windows) to this unit by using the AirPlay or DLNA
feature. ( 15, 17)
To use these features, this unit must join the same network
as the AirPlay compatible device or the DLNA compatible
device.
Wired LAN connection
Normally, just connecting a LAN cable will complete the
setup.
This unit
(rear)
Broadband router, etc.
A: LAN cable (not supplied)
1
Disconnect the AC mains lead.
2
Connect this unit to a broadband router, etc.
using a LAN cable.
3
Connect the AC mains lead to this unit, and
press the unit on/off button to the [
position. ( 12)
14
(14)
To make network-related
settings
You can change this unit's name on the network (Friendly
Name), and use specific IP address, subnet mask, default
gateway, primary DNS, etc.
≥ Do not play back music while changing these settings.
1 Press [SETUP].
2 Press [3, 4] repeatedly to select "Network" and then
press [OK].
3 Select and input the details.
4 Press [OK] to apply the settings.
5 Press [RETURN] repeatedly to exit the settings.
6 Press [Í] to turn the unit to standby mode.
≥ Wait until "Please Wait" disappears.
7 Perform "Wired LAN connection". (
≥ Use category 7 or above straight LAN cables (STP) when
connecting to peripheral devices.
≥ The LAN port and the system terminal are identical in shape. Be
careful not to mistakenly connect the LAN cable connected to
another device, such as a broadband router, to the system
terminal.
≥ Inserting any cable other than a LAN cable in the LAN port can
damage the unit.
≥ If you change the network settings immediately after turning on
this unit, it may take some time until the changes are applied.
PC, etc.
]
left)