Miele A 623 Mode D'emploi page 36

en - Areas of application
Tall measuring cyl-
inders
Short measuring
cylinders
36
Depending on the height of the measuring cylinders, the following
must be observed:
The openings of the measuring cylinders should rest between the
support hooks on the injector nozzles to stabilise the cylinders during
reprocessing.
If the measuring cylinders cannot be placed between the support
hooks, the angle between the measuring cylinders and injector
nozzles must be adjusted. To do this:
- Move the holder frame into another recess on the strut
The measuring cylinders must rest on the plastic supports of the in-
jector nozzles. However, they must not be allowed to touch the
nozzles themselves.
If the measuring cylinders are touching the nozzles, the angle
between the measuring cylinders and the injector nozzles must be
altered. To do this:
- Move the holder frame into another recess on the strut
or
- Slide the plastic support on the injector nozzle downwards