Operating instructions
GB
1. Introduction
Read through these operating instructions fully and carefully. The operating
instructions belong to this product and contain important points concerning
bringing the appliance into service and ist operation.
Also read the operating instructions of the basic set.
Always pay attention to all safety instructions. Should you have any questions
or be unsure about operating the appliance ask a specialist. Keep these
instructions in a safe place and should the need arise pass them on to a third
party.
2. Proper use
The digital wireless camera set consists of the camera DF-200K and the mains
adaptor model KSAB0500100W1EU.The additional camera is an optional
accessory for a DF-200 series set which contains an receiver/monitor. It is to be
used for the surveillance of rooms, entrance hallways, driveways etc. through
video pictures and sound. The video and audio transmission is wireless using a
frequency of 2.4GHz.
The power is supplied through the supplied mains adapter connected to a
230VAC, 50Hz mains supply.
If there is sufficient light a colour picture will be transmitted. At low ambient
light levels the integrated Infrared LEDs are automatically switched on. In this
case the immediate area (within 8m indoors and 5m outdoors) will be
illuminated and the video picture switches to black and white mode for
improved light sensitivity. If the surveillance is specifically required in a dark
environment, then additional lighting should be installed.
Up to four wireless cameras DF-200K can be used with one monitor/receiver.
The camera channels can be manually selected or automatically displayed in
sequence if the scan mode is selected. Depending on the model the camera
pictures can also be observed simultaneously in quad-split screen mode.
The wireless transmission is digital and on constantly changing frequencies
(frequency hopping) which are synchronised between the camera and the
monitor. Only the receiver which has been "paired" with the camera can receive
the synchronised signals. This security feature prevents access of the camera
signal by third parties.
The camera is weatherproof (Protection class IP44) and can be used not only
indoors but also in a location outdoors which is sheltered from direct rainfall.
The receiver and both mains adapters are for indoor use only and must be
protected from moisture. The set is for use in private households. A video
surveillance system does not replace your duty of care or supervision. Observe
the regulations concerning video surveillance in commercial and public areas.
Any other use or modification of the device is not authorised. No liability will be
accepted for consequential damages or for damages caused by improper use or
incorrect operation. No liability will be accepted for consequential damages
caused by any function or by malfunction. Unless any liability is specifically
required by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the machine,
are excluded.
This appliance is not intended to be used by people (including children) with
restricted physical, sensory or mental capacities, or a lack of experience and/or
knowledge, unless they are supervised by, or receive instructions how to use the
appliance from a person responsible for their safety.
3. Package contents
! DF-200K camera with connection cable to mains adapter
! Radial antenna 3dB
! Mains adapter 5VDC
! Camera bracket with screws and plugs
! User manual
4. Features and Equipment
Camera DF-200K (s. Fig. A)
1
Camera
2
Metalhousing
3
U-bracket
4
U-bracket screws
5
Mains adapter connection
6
Inner housing
7
Antenna connection
8
Rubber flap
9
Power LED
10
Infrared LEDs
11
Daylightsensor
12
Connection-LED
13
"Pairing"-Button
14
Microphone
15
3 dB radial antenna
16
Triangular nut
17
Wing screw
18
Bracket
19
Mains adapter
20
Plugs
21
Screws
5. Technical data
Operating Voltage
Current consumption
Ratio-frequency
Modulation
Channels
Light sensitivity
Resolution (Pixel)
Audiofunction
Picture
Radio range (max.)
Operating temperature
Protection class
Dimensions without antenna (mm) 176 x 64 x 42
5 V
DC (mains adapter)
650 mA
2400 -2483 MHz
GFSK
4
1-8 Lux (w/o IR-LEDs)
640 x 480 (VGA) / 320 x 240 (QVGA)
microphone
colour (b/w with IR)
100 - 200 m (open space)
- 10° C to + 50° C
IP 44
GB - 13