ROSIERES TC 04 Notice D'emploi Et D'installation page 18

INSTALLATION: "BUILDING-IN"
Both the unit into which the hob will be fitted and any adjacent kitchen furniture must be made
from heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower part of the casing is adjacent to an area normally
accessible when handling or cleaning, fit a heatproof partition 1 cm below the base of the
casing, with a 10 x 10 cm opening in the rear right-hand corner, to avoid any risk of burning
or damage.
There should also be a 5 cm gap between the appliance and all adjacent vertical surfaces.
A foam adhesive seal is supplied with the hob. Stick this seal under the edge of the body as
near as possible to the outer edge of the hob. Press round the edges of the hob, so that the
seal flattens out and ensures an air tight seal.
Fitting the seal
Top view of the hob
SEAL
Building-in according to TYPE Y
(Norm EN 335-2-6)
Opening 10 X 10 cm
560 mm
1 8