Zipper Maschinen ZI-COM24E Mode D'emploi page 24

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
15
TROUBLE SHOOTING
Disconnect the machine from the power supply prior to any checks performed at the machine
itself!
Trouble
Pressure can no
longer be stored
Engine overheats
Compressor runs
but produces no
pressure
Engine will not start
After reaching the
escapes cut-off
pressure
Compressed air
through the relief
valve und Pressure
switch to reach the
starting pressure
Compressor on
frequently
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-COM24E / ZI-COM50E
Possible cause
 Valve seals broken
 low oil level
 dirty air filter
 Clogged air filters
 Defective seals
 Defective valves in the cylinder
head.
 No power supply
 Overload protection activated
 Leaking or defective check valve
 Check valve is damaged
 Very much condensate in the
pressure boiler
 Overload compressor
 Replace the seals
 Refill oil
 Clean or replace the air filter
 Clean or replace the old air filter
 Replace the seals
 Replace the valves
 Check the connection to an existing
electrical grid.
 Let the engine cool down and then
pull the red pressure switch (on /
off)
 Clean or replace check valve insert
 Replace check valve
 Drain condensate
N O T I C E
TROUBLE SHOOTING
Solution
24

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zi-com50e

Table des Matières