Safety Instructions - KaWe 09.11010.002 Mode D'emploi

7
7. Set the required height of the glass drip dish.
Secure the brake rollers.
Prior to moving the infusion stand,
release the brake rollers.
Purpose: Holding stand for infusion bottles – infusion bottles
are allowed to have a maximum weight of 2 kg per suspension.
NOTE: It must be ensured that the maximum weight of
suspension of 8 kg is not exceeded! The weight must be
distributed uniformly in order to avoid a slanting position of
the infusion stand.
Guarantee: When used properly and with attention to this
User's Manual we guarantee this product for two years after
the date of purchase. Should you need further information or
should your instrument require repair, please contact your
dealer!

Safety instructions!

• The infusion stand is only to be used in good order and
condition.
• The infusion stand is only to be used on flat surfaces.
It must be ensured that the brake rollers are locked.
Stability is ensured with a load of 2 kg and a sloped
position of up to 10%.
• Prior to moving the infusion stand it must be ensured
that the brake rollers are released.
• The four clamps are only to be used for the infusion bottles.
• The user is liable for damages resulting from any use that is
not in accordance with the intended use of the unit.
Marking: This product meets EC Standards 93/42 EEC
(standards for medical products).
Technical data:
Maximum height
Stand foot diameter
Weight infusion stand
For further information about KaWe products visit:
www.kawemed.de
Cleaning: 1. Use alcohol-based cleaning agents. 2. Do not use
any acids. 3. Manual cleaning with e.g. Helipur, Baktolan or
Sagrotan in accordance with the instructions of the manufactu-
rers. 4. Dirt that has accumulated on surfaces must be removed
immediately. 5. Dirt that has accumulated on the rollers must
be removed in order to avoid static charge. 6. Automatic
cleaning is not possible. 7. No sterilization required.
Maintenance: 1. Regular visual and performance check of all
component parts – defective parts must be replaced. 2. If
necessary, re-tighten the screws.
Subject to technical modifications without prior notice.
Symbol key:
Manufacturer
Date of manufacture
LOT Lot code
Heed the User's Manual
Caution!
REF Product reference number
GOST-R certification for exports to Russia
7
approx. 210 cm
approx. 60 cm
approx. 3.4 kg