Sensor Reset; Battery Change; Decommissioning And Disposal - weinor BiSens Agido-3V Instructions De Service

Masquer les pouces Voir aussi pour BiSens Agido-3V:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Betriebs- und Einstellanleitung | Gebruiks- en instellingshandleiding | Operating and adjustment instructions | Instructions de service et de réglage

Sensor reset

If the sensor is already connected to another receiver , or if the
programmed tasks do not work properly, the BiSens Agido-V3
must be deleted from the receiver.
• Press the UP and dOWN keys at the same time for
3 seconds! The control LED flashes briefly for confirmati-
on. The sensor is reset and deleted from the receiver.
Note! The receiver will then cease to work using the
sensor / movement keys in the sensor and will need to
be re-programmed if required.

Battery change

To test at any time whether the sensor is working as it should
(i.e. that the awning retracts), simply shake the drop profile.
If the sensor is used permanently, a battery change is required
approximately every two years.
• Change the batteries in the BiSens Agido-3V as soon as the
awning drive briefly stalls twice when extending or retracting
(this is a visual indication that the batteries are almost dead).
Opening the housing
caution personal injury!
Risk of injury due to unintentional retraction of the
awning! Disconnect the awning from the power supply
to prevent the awning from retracting unintentionally
while the BiSens Agido-3V is opening!
• Loosen the two hexagon socket screws (Torx) and
take the top part
off! Pay attention to the seal
Replacing the batteries
• Take out the batteries and replace them with two new
batteries of the same type (micro, AAA, LR03). Make sure you
replace the batteries the right way round!
Micro,
Typ AAA, LR03
weinor GmbH & Co. KG
Functional check
• Press one of the two movement key on the device to check it
is working. The control LED must light up brightly!
closing the housing
caution personal injury!
Risk of injury due to unintentional retraction of the
awning! Disconnect the awning from the power supply
to prevent the awning from retracting unintentionally
while the BiSens Agido-3V is closing!
• Insert the sealing ring
ly ! Fasten the upper part
screws (Torx).
• S witch on the power supply again for the final
functional check and commissioning!
Functional check
• Check it is working properly by moving the drop profile by
pushing or shaking it (according to the set threshold
!

decommissioning and disposal

For the disposal of the device, the currently appli-
cable international, national and regional laws
and directives must be adhered to. Ensure that the
material recycling, dismantling and separation
capability of working materials and assembly groups
is taken into account as well as the environmental and health
hazards in recycling and disposal. Material groups such as
different kinds of synthetic materials and metals, must be
sorted before they are recycled or disposed of. disposal of
electrotechnical and electronic components: The disposal
and recycling of electric and electronic components must
be undertaken in accordance with the respective legal and
regional regulations.
and make sure it is inserted correct-
using the two hexagon socket
BiSens Agido-3V | 1178799-0000 w | v3.2 | 2020-02-03
value)!
19

Publicité

Table des Matières
loading

Table des Matières