Safety Instructions; Technical Specifications - weinor BiSens Agido-3V Instructions De Service

Betriebs- und Einstellanleitung | Gebruiks- en instellingshandleiding | Operating and adjustment instructions | Instructions de service et de réglage

Safety instructions

Warning! danger of electric shock due to incorrect
handling of electrical components!
Work on electrical fixed installation is only permissible when
conducted by electrically skilled persons according to VDE 100!
Do not operate the system in the event of damaged power
leads and contact an electrically skilled person in accordance
with VDE 100!
• Follow the details regarding the supplied electrical components
in the instructions!
• Regularly check the system for damaged power leads!
caution! Personal injury due to improper
operation, use and maintenance of the system!
• Follow the safety instructions that you received together with
the BiConnect / WeiTronic products!
• Make sure that no children or people incapable of properly
assessing the risks of improper or incorrect use are permitted
to operate the system!
• Always keep the remote radio control out of reach of children!
• Keep all documents handed over by the installer of the system
and listed below in a safe place, dry and, if necessary, easily
accessible place:
– Your duplicate of the handover protocol,
– The maintenance instructions and directions for use,
– Instructions for accessories and add-on options,
– The assembly instructions,
– The drive, commutator or control system manufacturer's
adjustment and operating manual,
– The quick guide and supplements
Attention! Property damage!
Only suitably qualified, authorised persons should carry out any
repairs to the sensor
• Do not interrupt an UP movement triggered by the sensor
unless you are sure that it will not damage the awning!
Note! The radio control is delivered programmed
(default). Once the awning has been connected to the
power supply, it can then be operated directly with
the handheld transmitter. In rare cases or in case of
servicing, the radio control must be initialised on site.
Setting the sensitivity level
The sensor is delivered set to "Threshold value 4". The threshold
value in the sensor can be adjusted inside the device using a
screwdriver. The possible threshold values range from 1 (very
high sensitivity; reacts to a light breeze/gentle shaking) to 10
(very low sensitivity; only reacts to strong winds/shaking). The
batteries must be removed to deactivate the sensor.
weinor GmbH & Co. KG
BiSens Agido-3V technical specifications
Power supply Alkaline battery, AAA, LR03
Permissible ambient -15 to + 50 °C
temperature only for use in the drop profile
130 x 47 x 27 mm
dimensions (mm)
(L/W/h) Hole spacing 100 mm
IP code IP 54
Radio frequency 868.3 MHz
Radio protocol BiConnect (bidirectional)
WeiTronic (unidirectional)
Switching methods UP command when the threshold
value is exceeded
threshold values 1 (very high sensitivity) to
10 (very low sensitivity)
BiSens Agido-3V | 1178799-0000 w | v3.2 | 2020-02-03
)
15