Setting The Sensitivity Level - weinor BiSens Agido-3V Instructions De Service

Masquer les pouces Voir aussi pour BiSens Agido-3V:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Betriebs- und Einstellanleitung | Gebruiks- en instellingshandleiding | Operating and adjustment instructions | Instructions de service et de réglage
• Once the receiver has been programmed, check that the
awning's direction of travel is correct.
• Press the UP key on the BiSens Agido-3V.
The awning must retract.
• Press the dOWN key on the BiSens
Agido-3V. The awning must extend.
(Sun protection).
If the direction of travel is not as indicated, the
BiSens Agido-3V must be deleted from the receiver
(see "Sensor reset" section), the transmission mode
must be set and the receiver must be programmed
again (see previous page). When doing so, pay
special attention to the awning direction.
• After connecting the awning to the power supply, it is
important to check that the handheld transmitter and all
the supplied sensors are working:
- Can all the components be operated (awning, valance;
lights, if installed) using the handheld transmitter?
- Are all the sensors programmed correctly?
- Simulated "wind" on sun/wind (rain) sensors
(awning retracts)?
• Shake the drop profile – does the awning retract?

Setting the sensitivity level

The sensor is delivered set to "threshold value 4". The possible
threshold values range from 1 (very high sensitivity, reacts to
a light breeze/ gentle shaking) and 10 (very low sensitivity,
only reacts to strong winds/shaking)
• Adjust the product protection sensor's threshold value using
a screwdriver on the controller inside the device if the awning
reacts too little or too sensitively when you shake the drop
profile!
• Now set the threshold value for regular use to a less sensitive
level. We recommend that you select threshold value 4 or 5
to begin with
.
• Adjust the threshold value, for example to a small value
(up to "1")!
. When the sensor is very gently shaken,
the awning should already retract immediately
18
BiSens Agido-3V | 1178799-0000 w | v3.2 | 2020-02-03
Note! The receiver switches to a "wind lock" for about
15 minutes. It is not possible to stop the awning moving
using the StOP key on the handheld trans mitter during
this time. To stop the movement nevertheless, switch
the awning off briefly, e.g. using the fuse. This cancels
the "wind lock" mode and the awning can be operated
normally again.
closing the housing
caution personal injury!
Risk of injury due to unintentional retraction of the
awning! Disconnect the awning from the power supply
to prevent the awning from retracting unintentionally
while the BiSens Agido-3V is closing!
• Insert the sealing ring
Fasten the upper part
(TX20)!
.
• S witch on the power supply again for the final
functional check and commissioning!
• Check it is installed and operating correctly by moving the
drop profile by pushing or shaking it (according to the set
threshold value)!
4-5
and make sure it is inserted correctly!
using the two hexagon socket screws
weinor GmbH & Co. KG
1-2

Publicité

Table des Matières
loading

Table des Matières