Makita AN611 Manuel D'instruction page 6

► 1. Slot 2. Feeder body
Connecting air hose
► 1. Air fitting 2. Air socket
Lock the trigger. Slip the air socket of the air hose
onto the air fitting on the nailer. Be sure that the air
socket locks firmly into position when installed onto
the air fitting. A hose coupling must be installed on or
near the tool in such a way that the pressure reservoir
will discharge at the time the air supply coupling is
disconnected.
OPERATION
CAUTION:
• Make sure all safety systems are in working
order before operation.
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
1
2
1 2
2. Pull the trigger first and then place the contact
element against the workpiece.
• No. 1 method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
• However when the tool is set to the "Intermittent
Nailing" mode, WITH THE TRIGGER HELD IN
A HALF-PULLED POSITION, an unexpected
nailing could occur, if contact element is allowed
to re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, per-
form as follows;
A. Do not place the contact element against the work-
piece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailing.
• For No. 1 method, set the change lever to the
"Intermittent Nailing" position.
For No. 2 method, set the change lever to the
"Continuous Nailing" position.
After using the change lever to change the nailing
method, always make sure that the change lever
is properly set to the position for the desired nail-
ing method.
6 ENGLISH