Securing Dishwasher To Countertop - Haier HDBC100AFS Instructions D'installation

SECURING DISHWASHER TO COUNTERTOP

Depending on the material of your countertop, secure the dishwasher by using
either Method 1 - Non-Stone Countertop or Method 2 - Stone Countertop.
Method 1 - Secure to Non-Stone Countertop
The dishwasher must be secured to the wood countertop.
1. Open the dishwasher door and remove lower dish rack.
2. Place a towel over the pump assembly and spray arm of dishwasher to keep
screws from falling into pump area during installation.
3. Check that the dishwasher is level and centered side to side in the opening.
4. Check that the tub flange aligns with the front face of the cabinet frame.
5. Attach the dishwasher to the countertop using the 2 brackets on top of the
dishwasher.
NOTE: The dishwasher must be attached to the countertop to keep it from
tipping when the door is opened.
6. Insert 2 #8 x 5/8" Phillips flat-head screws through the brackets and into the
countertop.
7. Open the door about 3" (7.6 cm) and check that the space between the inner
door and tub is equal on both sides.
8. If spacing is not equal, loosen the bracket screws and shift the tub. Retighten
bracket screws.
9. Check that the top of the door does not contact the screws, brackets or
countertop. If it does, the dishwasher must be lowered and leveled again. See
"Level The Dishwasher" in "Install Dishwasher."
10. If spacing is not equal, loosen the bracket screws and shift the tub. Retighten the
bracket screws.
11. Remove towel from dishwasher.
12. Reinstall the lower dish rack.
24
brackets