Haier HDBC100AFS Instructions D'installation page 15

INSTALL THE WATERLINE
NOTE: Routing the water line through the left side of cabinet opening will make
water connection easier.
1. Drill a 1/2" (1.3 cm) hole in the cabinet
side, rear or floor. Preferred and optional
locations are shown.
2. Measure overall length of copper tubing
required.
3. Attach copper tubing to the water line with
a manual shutoff valve.
4. Slowly feed copper tubing through hole in
cabinet. Copper tubing will bend and kink
easily, so be gentle. The copper tubing
should be far enough into the cabinet
opening to connect it to the dishwasher
inlet on the front left of the dishwasher.
5. Turn water shutoff valve to "ON" position.
Flush water into a shallow pan to get rid of
particles that may clog the inlet valve.
6. Turn shutoff valve to "OFF" position.
INSTALL THE DRAIN HOSE
IMPORTANT: Always use a new drain hose.
1. Drill a 11/2" (3.8 cm) hole in cabinet wall or floor. on the side of the opening
closest to the sink.
2. Connect drain hose to waste tee or waste disposer using one of the following
methods:
•
Option 1, Waste disposer - with air gap
•
Option 2, No waste disposer - with air gap
•
Option 3, Waste disposer - no air gap*
•
Option 4, No waste disposer - no air gap*
optional preferred
locations locations
preferred optional
locations locations
copper
tubing
13