Level The Dishwasher - Haier HDBC100AFS Instructions D'installation

3. Move dishwasher close to cabinet opening. Do not push on the front of the panel
or on the console – they may dent.
4. If dishwasher has a power supply cord, insert power supply cord into hole cut into
cabinet.
If using direct wire, check that it is on the right front side of opening.
5. Check that water line is on the left side of opening and insert the drain hose
through the hole in cabinet.
6. Slowly move dishwasher completely into cabinet opening so that the front
corners of the dishwasher door are flush with the cabinet doors. Do not kink
or pinch copper tubing, drain hose, power supply cord or direct wire between
dishwasher and cabinet.
NOTE: Once the dishwasher is in position, you may have to support the front of
the dishwasher by either raising, lowering or shimming the front feet.
7. Remove cardboard from under dishwasher.
NOTE: It is all right if the dishwasher fits tightly into cabinet opening. Do not
remove insulation blanket – the blanket reduces the sound travel.

LEVEL THE DISHWASHER

1. Align front of dishwasher door panel with cabinet doors. You may need to adjust
alignment to be even with your cabinets.
NOTE: Prop up one side of frame to hold dishwasher up off floor when adjusting
front legs. With some installations, it may be easier to adjust the front leg using
the 6" adjustable wrench.
2. Check that leveling legs are firmly against the door
3. Close and latch the door, and place level against the front panel. Check that
dishwasher is plumb. If needed, adjust leveling leg or add shins until dishwasher
is plumb.
4. Repeat for other side of dishwasher.
18