Installation Of The Appliance; Connection Of The Pipes; Electrical Connection Of The Hood Sem1 - Elica SUM1 Guide D'utilisation, D'entretien Et D'installation

Installation of the appliance: after deciding the position and the type of installation, insert the
anti:vibration rubber caps in the holes of the brackets supplied fig. 5C.
The rubber caps must be put on the sides which are in contact with the wall.
Put the brackets (fig. 5A) on the remote fitted extraction motor by matching its holes with those
of the brackets. Fix with the screws supplied (fig. 5B).
Put the group on the point previously chosen for the installation and mark the points on the wall
where the holes must be drilled. Insert the dowels supplied in the holes (fig. 4A). Put the remote
fitted extraction motor on the wall by matching the holes of the brackets with the plastic dowels.
Screw with the screws sup: plied (fig. 4B).
Connection of the pipes: the appliance is endowed with an entrance and an outlet to connect the
pipes. Before connecting the exhaust pipes, check the direction of the air showed on the external
label (fig. 6). Connect the pipes and fix them with appropriate metal clamps (exhaust pipes and
metal clamps have to be supplied by the installer). The pipe (fig. 6A) must be con: nected with the
cooker:hood placed in the kitchen, and the pipe (fig. 6B) must be directed outside the building.
Electrical connection of the hood SEM1: the appliance is equipped with a 7m elec­trical cable with
a six) pin connection at one end. Insert it into the hood's connection (External Motor version).
8