Elipson IW6 Mode D'emploi page 19

Note : The flange of the speaker is designed to flex and conform to any small imperfections
in the wall surface. Tighten the 6 screws on the front of the baffle only enough to make
the flange become snug against the ceiling or wall. As you tighten the screws, the feet will
automatically flip into an outward position, thereby clamping the drywall between the feet
and the flange.
Caution : Over-tightening may warp the baffle, crack the wall, cause the flange to distort,
and make the grid difficult to install.
4. Secure the grid into place.
Note : The speaker flange incorporates high strength magnets to secure the grid into place.
Simply line the grid with the speaker flange.
IV. PAINTING INSTRUCTIONS
The grids can be painted. However, great care should be taken not to clog the holes, as this
will greatly reduce the sound quality of the speakers.
If you plan on paint your grids, we recommend that it be done prior to installation. The
scrim cloth backing must be removed prior to painting the grids. The surface should be
cleaned with a light solvent to remove any dust or residue. Elipson recommends a light
spray-painting using 5 parts thinning agent to 1 part paint. Do not paint the grid while they
are attached to the speaker.
19