Elipson IW6 Mode D'emploi page 17

4. Cutting the hole
Caution : this is the most important part of the entire installation. If you are uncertain
about obstructions in the mounting area, you should start by cutting a small hole within
the penciled area with a drywall saw. Cutting at a 45 degree angle will make drywall
repair much easier should you need to patch the hole due to obstructions. Once you have
determined there are no obstructions in your desired mounting location, start cutting the
finished hole at a 90 degree angle to the wall surface.
5. Add insulation
If the area in the ceiling or wall is not already insulated, add an adequate amount of
insulation material to fill the cavity. If the insulation material used is faced with foil or paper,
position the foil or paper away from the speaker.
The integral mounting-feet system incorporated into your speaker allows for a quick
installation by following these easy steps.
1. Remove the grid and set aside in a clean dust-free environment.
2.Attach the speaker cable (observing the proper polarity with your amplifier : + to +, - to
-). Make sure the left channel of the amplifier channel is connected to the left speaker
channel and the right amplifier channel to the right speaker channel.
17 17