Elipson IW6 Mode D'emploi page 16

UK
IV. INSTALLATION
Mounting surface preparations / Finished ceilings and walls
Prior to the actual installation of the speakers, it will be necessary to run cables to the
speaker locations. See your dealer for more informations on cable installation. After the
cable has been properly installed, you are ready to mount the speakers.
1. Determine the best area to mount your speakers
This area of the ceiling or wall should be free of obstructions such as electrical conduit,
HVAC ducts, or water lines. This can best be determined by noting the placement of fixtures
and gaining access to an attic or crawl space for further analysis of the location of such
obstacles.
2. Find the studs / joists nearest the desired speaker mounting location
We highly recommend using a good stud-finder tool for this procedure. If you are lining up
the speakers to some other object or molding in the room, make sure you consider the size
of the baffles flange, which extends beyond the mounting hole.
3. Make the hole
A punch out template for setting the hole is provided in the box. Position the template in
the desired position and pencil an outline on the wall or ceiling.
16