Connecting To An Audio System - NAD L56 Manuel D'installation

YOU CAN LISTEN TO THE SOUND OF AUDIO CDS AND DVD VIDEO DISCS IN STEREO
To S-VIDEO OUT
To VIDEO OUT
If the TV has an S-video
input, connect the DVD
player with the
S-video cable.
NOTES
• Refer to the owner's manual of your audio system as well.
• When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before
making any connections.
• If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case, move the DVD player away from the
tuner and radio.
• The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level. Otherwise,
the speakers may be damaged by a sudden high volume sound.
• Turn off the receiver before you connect or disconnect the DVD player's power cord. If you leave the receiver power on, the speakers may be
damaged.
WARNING
Do not set the Digital Audio Output of this DVD player to "Dolby Digital" unless you are connecting the DIGITAL AUDIO jack of this DVD player
to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers (Refer to
"Selecting Digital Audio Output" on page 37).
Audio Cable (Supplied)
Video cable (Supplied)
To video input (yellow)
S-video cable (not supplied)

CONNECTING TO AN AUDIO SYSTEM

Audio System
To audio inputs of
the amplifier
TV or monitor with
audio video inputs
Installation
19
GB