Hand Guard - Husqvarna K 7000 Chain Manuel D'utilisation

This function locks the power trigger and stops the
product. The water valve goes back to closed position.
To do a check of the power trigger lockout
1. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
2. Push the power trigger lockout and make sure that it
goes back when you release it.
8
3. Make sure that the power trigger and power trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full speed.
5. Release the power control and make sure that the
diamond chain stops in less than 10 seconds and
stays stationary.

Hand guard

WARNING: Make sure that the hand guard
is correctly installed before you start the
product. Do not use the product if the hand
guard is missing, defective or has cracks.
1455 - 003 - 03.03.2020