Technical Data; Cleaning And Maintenance; Carbon Brushes - Matrix CP 900 Notice Originale

· Spread the polishing paste evenly over the
polishing pad. Do not apply the polish directly to
the polishing surface.
· Switch the polishing machine on and off only
when the polishing machine is resting on the
polishing surface.
· Place the extension lead over your shoulder and
work first on the large, flat surfaces such as the
bonnet, boot lid and roof.
· Keep your movements as regular as possible.
· Important! Allow the polishing machine to glide
over the polishing surface. Do not exert pressure!
· Work next on the smaller surfaces (doors, for
example)
- Use the fleece attachment to finish off the
polishing (Fig. 7).
· Make sure that the fleece attachment is free of
all foreign bodies.
· Remove the layer of polish in the same order as
it was applied.
· Important! Do not exert pressure on the
polishing machine!
Care tips
· For optimum paintwork protection, you should
polish your car 2 to 3 times a year.
· Wash your car at least every 2 weeks. Avoid
using household detergents as these can damage
the paintwork and remove the layer of wax.
· Wash your car with a clean sponge, working
from top to bottom.
· Remove all insects, bird droppings and tar stains
from the paintwork daily.
· If you use any window-cleaning agents, spray
them onto a cloth and not directly onto the
windows in order to prevent them wetting the
paintwork.

5. TECHNICAL DATA

Voltage:
Power rating:
Speed:
Polishing / sanding disk diameter:
Connection thread:
L sound power level:
WA
L sound pressure level:
PA
Vibration a
Totally insulated:

6. Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
6.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.

6.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
6.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7. Repairs
Only use accessories and spare parts
recommended by the manufacturer.
If the equipment should fail some day in spite of
our quality controls and your maintenance, only
have it repaired by an authorized electrician.
230-240 V~ /50 Hz
900 W
If the supply cord of the appliance is damaged,
-1
600-3000 min
this has to be done by the manufacturer or his
150 mm
agent or electrician in order to avoid a safety
M14
hazard.
95,47 dB(A)
84,47 dB(A)
25
:
ah,P
We recommend that you clean the device
2
9,267 m/s
II/