Table des Matières
Publicité
Installation Guide: Insert the hose into the
connector. Push item C into the connector to lock
the hose with the bag. (B7)
Dismantling Process: Push the locked connector
with the screwdriver. Pull the hose out. (B8)
5) Adjustment of suction power (B9)
Rotate the suction power adjuster to adjust the
suction power to a proper value. The bigger the
opening , the less the suction power.
7. After use
1) Switch off the power tool as described,
disconnect it from the power supply and let it
cool down.
2) Clean and maintain the power tool as
described below, and store it carefully.
8. Maintenance and service
1) Replacement of carbon brush
The carbon brushes are expendable. It is keeping
abrasion during use.
The carbon brushes should be checked regularly.
In order not to damage the electrical circuit, both
carbon brushes should be changed at the same
time.
CAUTION!
Replacing the carbon brushes should be done by
authorized service only.
The machine should be used only with both
brushes!
2) Cleaning
Regular cleaning shall be conducted after
grinding
• Cleaning the devices frequently may help to
extend operating life and reduce repair rate. It
is recommended to clean the connection sets
and components of electric motor without
application of water.
• Timely cleaning is recommended after the
application of the devices.
28
• Clean the devices with a hairbrush and a piece
of dry cloth, or simply blow it with high pressure
gas.
3) Service
Have your electrical tool maintained exclusively
by qualified specialist and using identical spare
parts. This guarantees that technical safety is
maintained during use.
9. Technical data
Rated voltage:
Rated frequency:
Rated power:
Rated no-load speed:
weight:
Spindle thread:
Abrasive pad size:
Rated sound pressure lever:
Rated sound power lever:
vibration:
Vibration declaration according to EN60745
The following information:
• that the declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another;
• that the declared vibration total value may also
be used in a preliminary assessment of exposure
A warning:
• that the vibration emission during actual use of
the power tool can differ from the declared total
value depending on the ways in which the tool is
used; and
• of the need to identify safety measures to
protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
220-240 V~
50 Hz
1200 W
1300-3000 r/min
3,5 Kg
M14
210 mm
86,6 dB(A), K=3 dB(A)
97,6 dB(A), K=3 dB(A)
2
4,462 m/s
, K=1,5 m/s
2
Publicité
Table des Matières
