Cleaning And Maintenance - ARIETE ECO POWER 2788/2 Mode D'emploi

After using the cleaner
Switch off the appliance using the foot switch (F).
Then unplug the appliance from the mains power and hold down the foot pedal (C) on the appliance
until the power cord is fully rewound.
WARNING: While rewinding the power cord, guide it in the right direction by hand to prevent any
risk of injury to yourself.
Put away the appliance, placing the floor brush (O) on the special hook in the back (Fig. 5).
Carrying the vacuum cleaner
Only carry the appliance using the special handle on the top part (G).

CLEANING AND MAINTENANCE

WARNING: Before carrying out any cleaning or maintenance operation, switch off the appliance and
unplug it from the mains power.
The dirt vacuumed up will enter the dust container (A). The air is cleaned by a permanent washable
filter that is located inside the dust container, by a motor protection filter and an air outlet filter located
under the appliance.
WARNING: Never use the vacuum cleaner if any filter is missing or damaged. Any dust cleaned up
will enter the appliance and damage the motor.
WARNING: Clean the filters regularly or in any case, whenever the suction power seems to be
reduced.
How to empty the dust container (A)
When the container is full, the LED (D) on the top of the appliance will switch on.
- Press the release button (E) and at the same time take out the dust container (A) using the handle
(G) (Fig. 6).
- Empty the dust container (A), opening the lid with the release button (Fig. 7).
IMPORTANT: To empty the container and prevent any dirt from leaking out, we recommend first
placing it inside a plastic bag and emptying it there.
- To clean the container (A) fully, it is necessary to disassemble it completely, as described here
below:
- remove the whole filter by turning it clockwise (Fig. 8);
- separate the filter into its two sections, sliding them apart (Fig. 9).
IMPORTANT: Wash the filter in clean water without soap or detergents. It is advisable to clean the
filter at least every 6 months or in any case, when suction is visibly reduced.
- Before using the appliance again, reassemble the container (A).
- Fit together the two filter components, inserting the tabs on one part perfectly into the slots on the
other.
- Place the filter inside the container (A) and lock it into place by turning it anticlockwise (Fig. 10).
- Now refit the whole dust container (A) onto the appliance body, pressing gently until it clicks into
place (Fig. 11).
- 11 -
EN