SOLIS MASTER CHEF 834 Mode D'emploi page 39

Step 4
Select the required function (Blend, Smoothie
or Ice/Auto Pulse) by pressing the corresponding
function button. The blender will start to operate
and only the selected function button will illumi-
nate. The «Power» button will continue to flash.
nOTe:
The speed can be changed at any time during the
blending process. Each time a new function is
selected its button will illuminate and the previous
function button illumination will go out.
Step 5
For ice-crushing or ingredients that require
short bursts of power, select the Ice/Auto
Pulse button. The blender will start to operate
and the Ice/Auto Pulse button will illuminate.
The ‹Power› button will continue to flash.
nOTe:
Operate the blender only for the appropriate
amount of time required. The Master Chef Blender
will automatically stop blending on the Blend func-
tion after 120 seconds (2 minutes) and after
60 seconds (1 minute) on the Smoothie and Ice/
Auto Pulse functions to avoid over processing.
The pre-programmed functions have been designed
to run for a specific time.
Function
Blend
Smoothie
Ice/ Auto Pulse
Step 6
To stop blending at any time, press the «Stop»
button or the selected speed button. The «Power»
button can also be pressed, but this will also turn
the appliance off and all illuminations will go out.
nOTe:
The smoothie function has a processing technique
that blends the denser ingredients at a lower speed,
then increases as ingredients thicken. This may
happen several times while blending smoothies.
Anl_MasterChefBlender_2.indd 39
Programmed Time
120 seconds (2 minutes)
60 seconds (1 minute)
60 seconds (1 minute)
Step 7
At the end of use, always ensure the blender is
turned off by pressing the «Power» button on the
control panel. Then unplug the cord. Ensure the
motor and blades have completely stopped before
attempting to move the appliance, or when the
Solis Prestige Blender is not in use and before
disassembling, cleaning and storing.
nOTe:
During the blending process, ingredients
may stick to the sides of the blender jug. To push
the food back onto the blades, press the «Power»
button on the control panel and remove the power
cord. Remove the lid and use a plastic spatula to
scrape down the sides of the jug. Replace the lid
before recommencing blending.
nOTe:
If the blades become stuck, the blender will auto-
matically turn off. To reset turn the blender off at
the power outlet, clean jug with spatula and then
turn back on, blender will reset.
nOTe:
If any moisture or liquid appears on top of the mo-
tor base during blending, press the «Power» button
on the control panel, switch off at the power outlet
and remove the power plug. Remove the
blender jug. Wipe the motor base immediately with
a dry cloth or paper towelling to absorb the liquid.
Check the blender jug is correctly assembled.
E
39
12.6.2008 10:47:26 Uhr