Troubleshooting Guide - Denon DVM-1805 Mode D'emploi

If the DVD player does not perform properly when operated as instructed in this Instruction Manual, check the
player by consulting the following checklist.
Symptom
No power
The player does not
respond to the
remote control.
No picture
Disc cannot be
played
No sound
Distorted picture
Audio or subtitle
language does not
match the setup.
The camera angle
cannot be changed.
Audio or subtitle
language cannot be
changed.
"Prohibited icon"
appears on the
screen.
The tray cannot be
open or close.
Notes
Some functions are not available in specific modes, but this is not a malfunction. Read the description in this
Instruction Manual for details on correct operations.
¡
Playback from a desired track and random playback are not available during program playback.

TROUBLESHOOTING GUIDE

Cause
¡ Loose power plug.
¡ The remote control is not aimed
at the sensor on the player.
¡ Obstacles present between the
remote control and the sensor.
¡ The remote control is too far
away from the player.
¡ Dead batteries.
¡
Loose video connection.
¡ Wrong disc.
¡ No disc.
¡ Dirty disc.
¡ Disc is placed upside down.
¡ Parental lock is active.
¡ Loose audio connection.
¡ The power of the connected
audio component is off.
¡ Wrong audio output settings.
¡ Wrong input settings on the con-
nected audio component.
¡ DTS sound is being output
through the analog audio out jacks.
¡ Copy protection is active.
¡ Immediately after playing, press
fast forward or in reverse.
¡ The 1st layer is switching to the
2nd layer, when playing a two
layered disc.
¡ The selected language is not
available for audio or subtitles
on the DVD.
¡ The DVD does not contain
sequences recorded from
different camera angles.
¡
The DVD does not contain
audio source or subtitles in the
selected language.
¡ That operation is prohibited by
the player or disc.
¡ The setup menu is displayed.
¡ Insert the power plug firmly into the wall outlet.
¡ Aim the remote control directly at the sensor on
the player.
¡ Remove the obstacles from the signal path.
¡ Use the remote control within 7m of the player.
¡ Replace the batteries.
¡
Connect the video cables firmly.
¡ Insert a correct video disc that plays on this player.
¡ Insert a disc.
¡ Clean the disc.
¡ Place the disc correctly, with the label side up.
¡ Cancel the parental lock or change the control
level.
¡ Connect the audio cables firmly.
¡ Turn the power of the audio component on.
¡ Correct the audio output settings.
¡ Correct the input settings on the audio
component.
¡ Use the DIGITAL audio jack for the connection
or set DTS off.
¡ Connect the player directly to the TV.
¡ There are some cases where pictures may be
slightly distorted, which are not a sign of a
malfunction.
¡ Although Pictures may stop for a moment, this
is not a malfunction.
¡ No malfunction.
¡ No malfunction.
¡
No malfunction.
¡ No malfunction.
¡ Cancel the setup mode.
– 30 –
Remedy