Sonnet Crescendo PCI G3 Manuel D'installation page 145

PCI TriManual-Chapters 1-13
En
Installation Overview
This overview is intended for those with prior
experience installing Sonnet upgrade products or
Macintosh ® hardware. We strongly recommend
following the full installation instructions if this is
your first installation of this hardware.
Installing the Crescendo card takes a few easy steps:
1) Install Mac OS 9.x (only if upgrading as part of
this installation)
2) Install Sonnet software
3) Shut down computer
4) Remove case cover from computer
5) Remove current processor card
6) Reset CUDA switch on logic board
7) Install Crescendo card into Processor Card Slot
8) Replace case cover onto computer
9) Affix the Powered by Sonnet label to front of
computer
10) Turn on your newly upgraded computer
11) Reset computer's date and time
12) To upgrade to AltiVec-enhanced software, see
Chapter 10
For more complete instructions, follow the installa-
tion procedure outlined in the pages that follow.
3/30/01 5:57 PM Page 127
9-2