Using Time Warp; Saving A Project - TORAIZ SQUID Mode D'emploi

Using TIME WARP

The Time Warp function can be used to automatically loop record the
output from the unit so that you can call patterns previously played.
1 Press the [TIME WARP] button.
The [TIME WARP] button changes from a dim white light to a bright
white light.
The display shows the length of the pattern to be previewed.
! If the [TIME WARP] button is pressed during pattern playback,
the unit plays back to the fourth beat indicator (the [TIME WARP]
button flashes), and then enters Time Warp mode (the [TIME
WARP] button lights up).
! The pattern cannot be changed while in Time Warp mode.
2 Turn the rotary selector.
The pattern can be previewed in different lengths: [1 Bar], [2 Bars],
[3 Bars], [4 Bars].
The lengh of the pattern to be previewed
3 Press the desired pad to begin previewing.
The unit plays the loop with the length specified in step 2 from the pad
that was pressed.
The pads that light up brightly are in the preview range. The pads with
a dim light can be selected to start the preview. The preview cannot be
started at pads that do not light up.
! The preview restarts each time a pad is pressed.
! To stop a preview, press the [g] (stop) button.
! The length of one pad is 1 Bar.
4 Press the [PATTERN] button.
The unit enters Save mode and the [PATTERN] button lights up green.
The pad of the current pattern lights up brightly. The pads with saved
patterns have a dim light. The pads do not light up when there are no
saved patterns.
5 Press the desired pad to save a pattern being
previewed.
The pattern is saved and the pressed pad lights up.
! A pattern cannot be saved to the pad with the current pattern.
6 Press the [PATTERN] button again to exit Save mode.
The [PATTERN] button dims green.
7 Press the [TIME WARP] button again to exit Time
Warp mode.
The [TIME WARP] button changes from a bright white light to a dim
white light.
The beginning of the preview

Saving a project

1 Press the [GLOBAL] button.
The [GLOBAL] button lights up and the display shows the GLOBAL
menu.
2 Turn the rotary selector to select [Save As], and press
the rotary selector.
! Select [Save] to overwrite the project.
3 Press the [c]/[d] button to move the cursor and
change the character by turning the rotary selector.
Name the project by repeating this step.
! Alphanumeric characters, symbols, or a blank space can be
inserted.
! To delete a character in front of the cursor, press and hold the
[SHIFT] button and press the [BACK] button.
! To insert a blank in front of the cursor, press and hold the [SHIFT]
button and press the rotary selector.
! When an existing project is opened, the name of the project
appears in the display.
4 Press the rotary selector.
The project is saved.
13
En