Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
HoW To oPeraTe YoUr
CoMPressor
note
– Before initial operation, your nebulizer should be cleaned follow-
ing cleaning instructions, or as recommended by your physician
or DeVilbiss provider.
1.
Make sure the power switch is in the "
and unwrap power cord.
2.
Place compressor so that the rubber feet are resting on a
level, sturdy surface and upon which the controls can be
easily reached when seated. Never block the air open-
ings of the product or place it on a soft surface, such as a
patient's lap or a bed or couch, where the air openings may
be blocked.
3.
Plug power cord into an appropriate wall outlet.
DeVilbiss compressor/nebulizer must be oper-
ated on the specified power source to avoid risk
of electric shock and damage to the compressor.
4.
Wash hands.
5.
Connect one end of the nebulizer tubing to the compres-
sor air-outlet connector (Fig. B).
note
– During high-humidity weather conditions, condensation
(water build up) can occur in the nebulizer tubing.
6.
Assemble clean nebulizer parts by placing baffle down
in medication cup. Add prescribed medication into the
medication cup (Fig. 2). Holding cup stationary, screw on
nebulizer cap (Fig 3).
7.
Assemble mouthpiece and t-piece (if applicable) and insert
into the top of the nebulizer cap. If using an aerosol mask,
insert the bottom part of the mask directly into the top of
the nebulizer cap.
8.
Attach tubing to nebulizer air-inlet connector (Fig. 4).
9.
Press the power switch " " (Fig. 1) to start the
compressor.
10. Begin treatment by placing the mouthpiece between teeth.
10
A-3655X
" position (Fig. 1)
DanGer!
1
2
3
4
Publicité
Table des Matières
