HQ Power VDPC174 Notice D'emploi page 6

5. Press the button corresponding to the scanner you wish to assign.
6. While holding the mode button press the scene number corresponding to the slider which
controls the movement (example: If the pan is controlled by slider number 4, press and hold
the MODE button while tapping scene button 4).
7. When finished, press the MODE and FINE buttons simultaneously again to exit the ASSIGN
mode.
c. Scenes
• Programming a Scene
1. Enter the PROGRAM mode (See "Enabling the PROGRAM Mode").
2. Check the blackout key and verify that the LED is not lit. If the LED is lit, press it once to exit
the BLACKOUT mode.
3. Verify that the speed and fade time sliders are positioned at zero.
4. Press the scanner button corresponding to the unit you wish to control. You may control more
than one scanner at a time by pressing the button corresponding to the scanner(s) you wish to
program.
5. Move the faders and the joystick to the desired position. If necessary, you may select page B
to control channels 9 ~ 16.
6. Tap the bank UP / DOWN button to choose the bank you want to store this scene into. There
are a total of 30 banks you can select from. You may store up to 8 scenes in each bank.
7. Once all scanners are programmed into the desired position for one scene, tap the MIDI / REC
button to program this scene into the memory.
8. Tap the scene button you wish to store your scene into. All LEDs will flash three times. The
LCD readout will show the bank and scene.
9. To unselect the scanner(s) you have been programming and to switch to another scanner,
simply press the button of the scanner you have been programming again, deselecting it, and
select another scanner.
10. Repeat steps 2 to 7 until all scenes have been programmed.
11. If you do not intend to continue programming at this time, press and hold the PROGRAM
button for three seconds to exit PROGRAM mode. The LED will go out indicating this selection.
• Example of a Scene Programme
1. Enable the PROGRAM mode.
2. Tap the SCANNER 1 button to turn on its fader control.
3. Verify that the page is set on page A. If not, press the PAGE SELECT button to select page A.
4. Move the first and second faders all the way up to their maximum value position.
5. Select bank 1 using the bank UP / DOWN buttons.
6. Press the MIDI / REC button.
7. Tap scene 1 to store the first scene.
8. Repeat steps 4 to 7 until all scenes have been programmed into bank 1.
9. Tap the SCANNER 1 button to turn off the fader control.
10. When finished, disable the PROGRAM mode. You can now manually tap through what you
have just programmed.
• Editing a Scene
1. Enable the PROGRAM mode.
2. Press the bank UP / DOWN button to select the bank containing the scene you wish to edit.
3. Select the scene you wish to edit by tapping its scene button.
4. Use the faders and/or joystick to make the desired adjustments to the scene.
5. Once you have completed the changes, tap the MIDI / REC button.
6. Tap the scene button that corresponds to the scene you're editing. This will override the
existing scene.
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an
existing scene.
15.03.2010
VDPC174
6
Rev 01
©Velleman nv