User Servicing Instructions; Replacing The Fuse - Jenn-Air Euro-Style Série Instructions D'installation Et Guide D'utilisation Et D'entretien

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
NOTE: If the hood does not operate, check to see if the circuit
breaker has been tripped and that there is power to the unit.

USER SERVICING INSTRUCTIONS

Replacing the Fuse

1. Disconnect power
2. Using a flat-blade screwdriver, pry the fuse cover away
from the front panel of the downdraft hood.
3. Remove the fuse from the fuse holder by pushing it from
the bottom side with the screwdriver.
A
B
A. Fuse holder
B. Remote up/down switch connector
4. To avoid the risk of fire, replace the fuse with a 125 volt,
5 amp non-time delay fuse.
5. Push cover in until it locks into position.
6. Reconnect power.
17