ANSMANN Racing xMove 2.0 Ultimate Mode D'emploi page 8

Picture B
Connection diagram in the
Auto charging mode
5.3.1 Start to charge/discharge: after set up the mode
menu correctly, press "ENTER/START" key for more
than 2 seconds to start the process
8
Connection diagram in the balance
charging/storage/discharge mode
This screen shows the number of cells you set up and the processor
detects. "R"shows the number of cells found by charger and "S" is
the number of cells selected by you at the previous menu. If both
numbers are identical you can start charging by press "ENTER/START"
button. If not, press "MODE/ESC" button to go back to previous
menu, then carefully check the number of cells of the battery pack to
charge again. If you selected the AUTO mode or discharge mode, you
can pass over this screen directly.
This screen shows the present situation during charge process. To
stop charging press "MODE/ESC" key once; As you can see in the
sketch on left;
CHG = charging at auto mode · BAL = balance charging mode · FAS =
fast charging · STO = storage mode · DSC = discharge mode;
elapsed time;
voltage of battery;
Individual cell connection diagram
: for the cells count; : for the operating Mode
1 2
: charge/discharge current;
4 5
: capacity of charge/discharge
6
Instruction Manual
:
3
: charge/discharge