Controls - Thermor R4GHD-T2S Notice D'installation Et D'utilisation

Radiateur électrique à inertie maîtrisée
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Pilot Wire Connection Test
You may connect the pilot wire if your house has a scheduler or energy manager.
In this case, to check that the scheduling orders are correctly transmitted, conduct the following checks:
Orders
Received
power
Signal to
transmit
Mode Obtained
COMFORT
For scheduling through the pilot wire or carrier power, freeze protection and load shedding orders have priority.
The delay for switching over from comfort mode to eco mode is about 12 seconds.
2.4 - Lock the Device on its Wall Bracket
- Place the device on bracket S as shown. - Move the device
towards the bracket then lift (arrows 1 and 2).
- Insert the bracket flanges in the holes on the device and lower
(arrow 3).
- Lock by turning the two latches (V) half a turn, your device is
locked.

3 - Controls

Screen
Equilibrium
3.1 - Familiarization
First check that the device is on. If it is off, press and hold the
Activate the screen by pushing any key.
You may choose the heating mode by pushing the
Flashing data has not yet been validated.
You may also set comfort and eco mode temperatures using the
For more information regarding the numerous possibilities offered by your device, please consult the following
sections in this Guide.
If you do not use the controls the screen goes into standby mode.
3.2 - Control Screen Description
Ventilation function
Command lock
No
230V for 3s
COMFORT -1°C COMFORT -2°C
and
keys
Ventilation
230V for 7s
230V
ECO
and
keys
Lock
.
key to start.
and
keys and validating with
and
-115V negative +115V positive
FREEZE
SHEDDING
PROTECTION
HEATING STOP
OK/Validate -
Stop heating
.
keys then validating with
Information line
Heat indicator
Display T°C
Modes
LOAD
.

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

R4gvd-t2s

Table des Matières