Velleman SP200B Mode D'emploi page 6

TEST SENSITIVITY :
At any time, you can stop and try out the sensitivity of the setting by hitting you
car with your fist to see if that level of impact to the alarm .The siren will sound
if you hit the car heavy enough.
1. During the testing, there are two stages of impact sound effect on every level.
2. The first stage's sound, which is like a chirp, is the pre-warning sound. It
simulates the system in armed condition and the shock sensor sense a
moderate shock, so the systems send a pre-warning tone to warn the intruders
stay out.
3. The second stage's sound, which is like a ding-dong, is the triggered sound. It
simulates the system is armed condition and the shock sensor sense a heavy
shock, so the systems send a full triggered siren, alarming intrusion.
4. Only one chirp from siren when you hit the window heavy, maybe the sensor
is too dumb. Many chirps with ding-dong, when you hit the window heavy
maybe the sensor is too sensitivity. Both of them are not adequate.
5. Recommended setting the shock sensitivity is a chirp follow with a ding-dong
when you hit the window heavy.
EXIT THE PROGRAMMING MODE :
If you choose on a proper level, simply press button I to exit programming mode
and save this sensitivity level. Two chirps for confirmation. If you don't press
any button in 10 seconds, system will automatically exit the mode.
C. CHOOSING SIREN TONE -- 5 DIFFERENT SIREN TONE & MULTI
SIREN TONE :
ENTER PROGRAMMING MODE :
1. Upon disarm, within 10 seconds, press both buttons together for 2 seconds.
You will hear a confirmation chirp, now it is on programming mode.
2. Press button I to enter choosing siren tone .By pressing button I again, you
can scroll through 5 different siren tones & multi siren tone.
3. If you choose on a favorite tone, simply press button II to exit programming
mode and save the last tone played. Two chirps for confirmation. If you don't
press any button in 10 seconds, the system will automatically exit the
programming mode.
D. ORANGE WIRE LOOP
1. If your vehicle with electric cooling fan (switch off the ignition and remove
the key, the fan continues running), the orange wire loop must be cut and tape
both end to delete the voltage drop sensor.
SP200B
6
VELLEMAN