Connecting To The Input1/Output Terminals Of The Subwoofer; Before Connecting; How To Connect; Connection Example - Yamaha NS-SW1000 Mode D'emploi

Connecting to the INPUT1/OUTPUT
terminals of the subwoofer
Note
• Make sure that the "+" and "–" polarity markings of the
speaker cables are observed and set correctly. If these cables
are reversed, the sound will be unnatural and lack bass.
• Do not let the bare speaker wires touch each other, because
this could damage the subwoofer or the amplifier.
• If the connections are faulty, no sound will be heard from the
subwoofer or the speakers. Do not insert the insulation into
the hole. Sound may not be produced.
• To avoid accidents resulting from tripping over loose
speaker cables, fix them to the floor.
n

Before connecting

Remove the insulation at the
15 mm
tip of the speaker cable, then
(5/8")
twist the core wires together so
that they will not become
disarrayed and short-circuited.
n

How to connect

1.
Loosen the terminal's
Red:
positive (+)
knob, as shown in the
figure.
Black:
negative (
2.
Insert the bare wire.
3.
Tighten the knob.
4.
Test the firmness of
the connection by pulling lightly on the cable at the
terminal.
n
Connecting the banana plug
1.
Tighten the terminal
knob.
2.
Simply insert the
banana plug into the
terminal.
7
En
If you use the included system control cable to connect a subwoofer to a Yamaha component (that features a system
connector jack such as a YSP series component or Yamaha receiver), turning on or off the power to the connected
component automatically turns the subwoofer on or off.

Connection example

How the System Connection works
Turning on the power to the connected component
will automatically turn on the subwoofer.
* The indicator lights green.
Good No Good
• The POWER switch on the rear panel (
• To modify the settings of the connected components, please refer to the owner's manual that came with the respective
2
component.
1
• If the unit is turned off by pressing the STANDBY/ON switch on the front panel (
–
)
indicator (green) gently flashes and notifies you that the connected device is ON. Pressing the STANDBY/ON switch again or
3 turning the power of the connected component on again turns the unit power ON and the indicator (green) is lit.
The indicator during the system connection
Power of connected component
Power of the unit
1
* Lights only when the AUTO STANDBY switch is set to LOW or HIGH.
2

System connections

Subwoofer
page 4) must be set to ON in advance.
Indicator status Green light
Yamaha YSP series component or receiver
Supplied system
control cable
Turning off the power to the connected component
will automatically turn off the subwoofer.
* The indicator turns off.
page 4) during system connection, the
Green light
Red light*
(gentle flashing)
ON ON
ON
ON
(standby)
Off
ON Off
Off Off