Operating - Dirt Devil Handy Mode D'emploi

3 Operating

2.5 Converting to a standing
cylinder vacuum cleaner
With a few manoeuvres you can convert the
Handy Deluxe hand-held vacuum cleaner into
a fully functioning cylinder vacuum cleaner
(Fig. 7):
1. Attach the shoulder strap (Fig. 7/1)
ZChapter 2.4, "Attaching the shoulder
strap".
2. Push the long suction hose with the
handle (Fig. 7/2) into the suction nozzle.
3. Push the 3 insert tubes (Fig. 7/3) together
and then push them into the handle.
4. Put on the floor nozzle (Fig. 7/4).
5. Adjust the carpet/hard floor switch (Fig. 7/
5) depending on the type of flooring:
- Hard floor (Fig. 7/A)
Laminate flooring, tiles, PVC flooring,
etc.
- Carpet (Fig. 7/B)
Long and short pile carpets, runners,
etc.
NOTE:
Using the secondary air controller (Fig. 7/6)
you can reduce the suction power as
desired.
3 Operating
3.1 Vacuuming
WARNING:
Check the appliance before each use. A
damaged appliance must never be used.
There is a risk of injury.
ATTENTION:
Only use the appliance if the filter is intact
and dry, and inserted correctly. Make sure
that none of the openings are blocked.
Otherwise, the appliance can become
damaged.
14
.
1. Use the desired accessory ZChapter 2.2,
"Using the accessories".
WARNING:
Due to the high motor output, the hand-held
vacuum cleaner produces
angular momentum when switched on.
If the hand-held vacuum cleaner is switched
on without holding tight to it, there is a risk
that it will move in an uncontrolled way and
fall or knock down surrounding objects.
Therefore always
vacuum cleaner firmly when switching it on.
Before plugging it in, make sure that the on/
off switch (Fig. 4/4) is set to "0".
2. Insert the plug into the plug socket.
3. Hold the hand-held vacuum cleaner firmly
by the handle (Fig. 4/3).
4. Switch on the hand-held vacuum cleaner
using the on/off switch (Fig. 4/4).
ATTENTION:
Make sure that the air outlet openings
(Fig. 1/9) are free. Otherwise the suction
power will decrease.
3.2 Putting away
1. Switch off the cylinder vacuum cleaner
using the on/off switch (Fig. 4/4) and pull
the plug out of the socket.
2. Wind up the cable.
3. Store the appliance and any accessories
no longer required in a cool and dry place.
ATTENTION:
Never position the appliance directly against
heat sources (e. g. heating, oven). Avoid
direct sunlight. Heat can damage the
appliance.
„
If you want to store the appliance for a
longer period of time, empty the dust
container and clean it.
a powerful
hold the hand-held