Newa Pond Pratico advance 3000 Mode D'emploi Et Garantie page 30

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
Flow-through filter:
WARNING: the current symbol on the UV-C filter label indicates that it is necessary to carefully read
this operating instruction manual before operating, using and carrying out maintenance on the appliance.
WARNING: Both appliances (pump and UV-C filter) cannot be used by children under eight or persons
1)
with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instructions concerning use of the appliance in a safe way and understand
the risks involved. Children shall not play with the appliance because this is not a toy. Cleaning and
maintenance shall not be made by children without supervision. Children shall not play with the appliance
because this is not a toy. Cleaning and maintenance shall not be made by children without supervision.
EN
2) WARNING: disconnect all submerged electrical appliances in the pond before carrying out
installation and maintenance operations. If the connection plug or the electric socket should be wet,
disconnect the main switch before disconnecting the power supply cable.
3) The power cord cannot be repaired. If it is damaged, the entire appliance must be discarded. Only for
the UV clarifier it is possible to replace the power cord with a cord of the same kind. BUT THIS OPERATION
MUST BE PERFORMED BY QUALIFIED PERSONNEL ONLY.
4) These appliances must be supplied through a residual current device (RCD) having a rated residual
current not exceeding 30mA (Idn ≤ 30 mA).
5) WARNING: the UV-C filter contains an emitter with UVC rays, which may damage the eyes and
skin. Improper use or damage to their protective casing may cause harmful UVC radiations. If clearly
damaged, the appliances must not be used.
6) WARNING: it is prohibited to use the UVC lamp on the outside of the appliance.
7) Check that the voltage given on the appliance label corresponds to the mains voltage.
8) Before connecting the appliance to the mains, check that the cable and the appliance are not damaged in any way.
9) The appliance power supply cable must form an appropriate loop, facing downwards (DRIP LOOP - Fig. 4), to prevent any runoff
water from coming into contact with the socket itself.
10) Do not place the supply cable underground, but follow the installation instructions prescribed by the local regulations in
force, and consult a qualified installer and electrician.
11) When installing the appliance, do not use the supply cable to lift it.
12) Before starting up the appliance, check that it has been correctly installed.
13) Do not make any technical alterations to the appliance. Use only original spare parts and accessories.
14) The maximum temperature for the circulating liquid must not exceed 35°C.
15) WARNING: avoid exposure to direct sunlight. Do not use or keep the appliance in an area subject to freezing. In winter, it is
necessary to remove, empty and position the appliance so that it is protected.
16) The appliances must not be operated dry. Do not use these appliances for filtering caustic, abrasive, inflammable, aggressive
or explosive liquids, and even drinking water.
17) WARNING: never look directly at the UVC lamp when it is switched on.
18) WARNING: the UV-C filter contains glass. Handle with due care.
19) WARNING: never connect the filters to the public water supply network.
20) WARNING: the UV-C filters must not operate immersed in water. If they should accidentally fall into it, before recovering them,
disconnect the plugs from the power supply socket. Take the same care if you should notice that any parts of the appliance are wet.
21) PRTadv 3000/5000/7000 UVC - PRT adv 10000/15000: install and properly fix the filter near the pond edge, make sure that it
is nstalled in such a manner that it cannot get into the water accidentally, and that the area, where it is installed, is not subject to
flooding. Minimum safe distance from water should be 2 m, according to international standard IEC 60364-7-702.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE!
30

Publicité

Table des Matières
loading

Table des Matières