DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance page 96

With the INC (∧) and DEC (∨) keys the phase name is varied. Once this name has been
selected, press ADVANCE (>>) and the first available block number will be displayed:
With the INC (∧) and DEC (∨) keys, the block number will be increased or decreased.
Once this number has been selected, press ADVANCE (>>) and the number of the
following phase will be displayed with the first available name. Proceed, as many times
as necessary, as above to name the phases and select the block numbers. To end, press
ENTER
If you wish to return to the previous menu you should press the ESC key.
7.2 Copy program
This command allows for a programme to be copied from an existing one. The steps to
follow are the following:
After selecting COPY PROGRAM, press the ENTER key and the numbers of the first
programme saved in the memory will be displayed along with their name:
Phase:
SPIN
Block:
Text: Pre-wash 40 ºC
Save program?
ENTER: Accept
ESC: Cancel
COPY PROGRAM
Orig. program:
WHITES
52
1
1
1
90 ºC