Programme End; End Of Program - DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance

Before starting up the programme, the initial phase of a programme can be selected. If we
press the INFO key:
If we press ENTER, a screen appears with all the phases.
With the INC (∧) or DEC (∨) keys, we can select the phase from which we want to start to
run the programme. Then press START to validate the selection or ESC to exit the menu.

2.5.-Programme end

The programme can finish in several ways:
Normal end: the programme finishes when all the phases forming it finish.
Pressing the STOP key: from any point in the programme, pressing the STOP key and
then the ENT key.
Pressing the ADVANCE key: at any point of the programme, pressing the ADVANCE
key repeatedly or holding it continuously the end can be reached. As in the previous case,
if a spinning process was being carried out, first the braking of the drum will be allowed
during a few seconds before replaying the ADVANCE key again.
When a programme finishes, before the door can be opened the unwinding of the clothes is
carried out during 30 seconds, and the screen displays the following message:
After 30 seconds, a message appears on the screen accompanied by an acoustic signal,
indicating that the programme has ended and that the door can be opened:
→SEE PHASES
DELAYED START
PROGRAMMING
CONFIGURATION
→ Pre-wash
Wash
Rinse
Rinse
P2:WHITES/COLOUREDS 60 ºC
Unwinding
P2:WHITES/COLOUREDS 60 ºC
Spin

END OF PROGRAM

Open the door
21
30 ºC
60 ºC
COLD
COLD