Change Phase Name - DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance

With the INC (∧) and DEC (∨) keys, all the phases saved in the memory are displayed.
Once the phase has been selected, press ENTER.
If you wish to return to the previous menu you should press the ESC key.

5.3 Change phase name

This command allows for the phase name to be modified amongst the names created by the
user. The steps to follow are the following:
After selecting CHANGE PHASE NAME, press the ENTER key and the first available
phase is displayed:
With the INC (∧) and DEC (∨) keys, the name to be modified is selected. Press ENTER
to validate the selection.
With the INC (∧) and DEC (∨) keys, the character where the cursor is can be modified;
with the ADVANCE key (>>) the cursor goes on to the next character; the INFO key
changes from upper to lower case and to special characters; the STOP key erases all the
characters before the cursor. Once the name has been modified, press ENTER.
If you wish to return to the previous menu you should press the ESC key.
Copy phase name?
ENTER: Accept
ESC: Cancel
CHANGE PHASE NAME
Soaking
Change phase name?
ENTER: Accept
ESC: Cancel
44