DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance page 91

30. Time
This is the time that passes from the moment the water reaches the water level (without
thermal stop), the programmed temperature (with thermal stop) or the spinning time. The
possible values are:
1 to 99 min. in steps of 1:
31. Cooling temperature
This serves to specify the gradual cooling temperature of the water after ending the wash
with hot water and before emptying the tub. The cooling of the water is achieved by introducing
cold water until the water temperature lowers to the programmed temperature or the programmed
time is reached. The possible options for this parameter are:
30 ºC to 70 ºC in steps of 5 ºC : the water will cool to the specified temperature.
32. Cooling time
This is the time taken from the start of the cooling up to the drainage. The drum will
continue to spin at the programmed speed and rate. The possible values are:
0 to 99 min. in steps of 1 min.: if 0 minutes is selected, no cooling will be carried out.
33. Drainage
It serves to specify the water level in the drainage. The possible causes are:
0 : the tub will be completely emptied.
Min. : the water level is the lowest possible.
Low : indicates a water level above the minimum level.
Med. : indicates an average water level, above the lower level.
High : indicates a water level above the average level.
Max. : indicates that this phase will not be drained.
34. Unwinding
If this is a spin, it indicates if unwinding will be carried out afterwards. If this is not a spin,
it indicates if the drum should turn whilst the drainage is being carried out. The possible options:
Y : unwinding is carried out.
N : unwinding is not carried out.
35. 19, 21, 23, 25, 27, 29. Dosing time n
Indicate the additive n dosing time (up to 7 additives) during the filling of the tub. The
possible options are:
0
1 to 99 sec. in steps of 1: dosing time in seconds.
wash or spin time.
: the dosing is not carried out.
47