Télécharger Imprimer la page

Error Message Display - Pioneer DMP-555 Mode D'emploi

Publicité

OTHERS: TROUBLESHOOTING
÷ Static electricity and other external effects may cause this unit to malfunction. In this case, set the POWER switch to OFF, then switch it on again after the disc has come to
a complete stop.
÷ This unit cannot playback unfinalized (partial discs) CD-R or CD-RW discs.
÷ This component is designed to play 12cm discs and 8cm discs with a commercially available adaptor, eccentrically shaped discs cannot be played since damage or malfunc-
tion may result.
÷ The BPM value measured by the DMP-555 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference is a result of differences in the BPM value
measurement method; not a result of a fault with the player.

Error Message Display

When the DMP-555 player is unable to operate properly, an error code is displayed on the display panel. Check the error code displayed against the following table and take the
recommended action to correct the error. If an error code other than any of the error codes listed in the table below is displayed or if the same error code is displayed even after
corrective action has been taken, contact your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.
CD PLAYER ERROR
Error code
Description
E-7201
TOC READ ERROR
E-8301
START UP ERROR
E-8302
PLAYBACK ERROR
E-9101
MECHANICAL TIME OUT
CARD ERROR/CAUTION
Message
Description
ERROR
There is something wrong.
FULL
This card is full of data.
NO CARD
There is no card available.
NO TITLE
There is no valid title information.
NO TRACK
There is no track available.
NOT SDCARD
This card is not an SD memory card.
PROTECTED
This card is protected from rewriting.
READ ERROR
It is impossible to continue to read.
TOO SHORT
This track is too short to loop-play.
UNFORMAT
This card has not been formatted.
UNKNOWN
Artist is unknown.
Album title is unknown.
36
36
En/Fr
En
Possible cause and first aid
Disc is dirty.
Disc has a crack.
Player cannot recognize that disc.
= Please try on another disc.
If player does well, a cause is in that disc.
Disc loading/unloading mechanism is out of order.
= If a disc is still in the inside of the player, please turn off a power first and carry out forcible ejection of
the disc (See page 7).
Card is broken.
This card has no or enough space to write/record.
Card is not inserted correctly.
Card detection switch is broken.
Title has not been written.
Title is written in two-byte character format.
That card is new one and there has been no download operation done.
Download operation failed.
All of the downloaded tracks are unsupported format.
Current Playlist is empty.
MultiMediaCards are able to be played but not able to write/record.
The card is another type of the SD memory card family.
The card is broken.
Write-protect switch of the card is locked.
The card is a Read-only type memory card.
Data in the card is broken.
The length of the track is shorter than the length of one beat.
That track is made for CUE sampling stuff.
Detected BPM value is too small by miscounting.
The card had been formatted uncorrectly.
There is no valid artist name for the track.
There is no valid album name for the track.
Possible cause

Publicité

loading