Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
USB charger plugged into the mains supply. The appliance must only be used in battery-
powered operation!
Please do not use any chemical hair styling products, such as hair spray, before
straightening your hair, to avoid burning your hair. On the other hand, use of heat
protection products for the hair is recommended.
Attention: The appliance becomes extremely hot during operation! There is
danger of burn injuries if there is direct skin contact.
1.
Open the appliance by pressing the button for the safety locking mecha-
nism.
2.
Switch on the appliance via the "ON/OFF" button. The indicator light is
illuminated.
3.
Via the "+" and "-" buttons set the desired temperature. The temperature
can be set in 3 three increments from 160°C, 185°C or 205°C. The thicker
your hair the higher the selected temperature can be. Chemically-treated
hair should be straightened at a lower level.
4.
The indicator light flashes as long as the appliance is heating up. As soon as
the flashing goes out, the desired temperature is reached.
5.
Divide the combed hair into small strands that should not be wider than five
centimetres. If necessary separate the hair strands with a bobby pin.
6.
Open the appliance and place a strand of hair on the hair placement surface
between the two straightening plates.
7.
Close the appliance.
8.
Now move the appliance slowly and uniformly downward to the tips of the
hair. In this process always keep the firmly appliance closed. You should
never keep the appliance longer than two seconds at any point, so as not
to damage your hair. If you want to get a smooth, tight-fitting look, when
smoothing the hair strands you must always work close to the head. However
if you lift the appliance when straightening you get a lot of volume.
9.
Determine the temperature that offers the best results for you through trial.
10.
The charge status indicator informs you of the actual charging status of the
appliance. Indication occurs at 50%, 70% and 100%. The appliance must
be recharged as soon as the display for 50% lights up. If all three displays
are flashing the appliance can no longer be used until it has been recharged.
11.
Please bear in mind that the straightening plates are also still extremely
hot after use.
20
Copyright UNOLD AG | www.unold.de
Publicité
Table des Matières
