Operation; Cleaning And Care - Unold Premium Série Notice D'utilisation

oPeratIon

The plates of the hair straightener are ceramic-coated to protect your hair and leave it shiny after
straightening. Nevertheless you should not straighten your hair too often. Select the adequate
temperature for your hair type, as too high temperatures may burn your hair. This applies especially
to colour treated or otherwise chemically treated hair (e.g. perms). In this case, select a lower
temperature adjustment.
Before straightening your hair please do not use any chemical hair-styling products like hair spray to
avoid burning your hair.
attention: the appliance becomes very hot during operation. avoid direct skin contact. danger of burns!
1. Prepare your hair as described in the chapter
„Before first use".
2. Attention: your hair should be completely
dry before straightening. Straightening your
hair when it is still damp will damage your
hair. Therefore you should dry your hair well
using a hair dryer, if necessary.
3. Separate the combed hair into strands no
more than 5 cm wide. If necessary, separate
the strands using hair clips.
4. Connect the plug to a wall socket (220 -
240 V~, 50 Hz).
5. Switch the appliance on pushing the button
EIN/AUS [ON/OFF].
6. The display lights up and the initial
temperature of 150 °C is indicated.
7. Adjust the desired temperature using the
buttons „+" and „-". The temperature can
be adjusted to 150 - 230 °C in steps of
20°. The thicker your hair, the higher the
selected temperature may be. Chemically
treated hair should be straightened at a
lower temperature adjustment. Try and see
which adjustment gives you the best results.
The selected temperature will be indicated
correspondingly in the display.
8. Heat the appliance up for 2 minutes in
order to achieve the best styling result.
9. Open the appliance and place a small
section of hair between the straightening
plates close to the root.

cleanIng anD care

1. Unplug the appliance from the wall socket.
2. Let the appliance cool off completely placing it
on a heat resistant surface.
3. Never immerse the appliance or the lead
cable in water or other liquids to clean them.
4. Clean the appliance with a damp cloth.
5. Do not use
abrasive agents, steel wool, metal objects,
disinfectants or hot cleaning agents, since
they can damage the appliance.
12
any scrubbing sponges,
10. Shut the appliance.
11. Now work your way down slowly and evenly
to the ends of your hair. Maintain the
appliance firmly closed during this process.
Never work the same part for more than two
seconds to avoid damaging your hair. For
an even and straight look, work your way
straight down keeping the appliance close
to your head. Working your way through
slightly lifting the appliance will give your
hair more volume.
12. Please remember that the straightener
plates are very hot after use.
13. Switch the appliance off pushing the button
EIN/AUS [ON/OFF ].
14. TIP: You can also curl your hair with the
straightener! Place the strand between the
plates as usual and straighten your hair.
Shortly before the ends of your hair, turn
the appliance to the inside or the outside
(according to the desired look) to give your
hair a gentle movement to inside or the
outside.
attention: the appliance becomes very hot
during operation. avoid direct skin contact.
danger of burns!
6. Protect the appliance from dust and clean
the air inlets with a soft brush, if necessary.
7. Clean the straightener plates with a damp
cloth, if necessary. Let the appliance dry
completely before using it again or storing
it. Persistent dirt can be easily removed with
a soft brush.