Gearcase Maintenance; General Cleaning And Tightening - Maruyama E23 Manuel Du Propriétaire/De L'utilisateur

3. Lubricate the flexible drive shaft with a high qual-
ity #2 lithium-base bearing lube.
4. Reinstall the flexible drive shaft into the drive
shaft tube. Twist the flexible drive shaft as you
insert it into the to ensure that it seats into the
clutch drum.
5. Reinstall the gearcase onto the drive shaft tube,
then tighten the two Phillips hex head screws.

Gearcase Maintenance

Maintenance Interval
The gearcase should be checked for lubrication after
each 30 hours of use.
Gearcase Lubrication
Bearing Lube
(P/N 211337)
Gearcase
Attaching Shaft
Remove the cutting attachment and the boss adapter.
Clean any dirt and debris from the area between the
boss adapter and the gearcase. Remove the grease plug
from the side of the gearcase. While rotating the
attaching shaft, inject lithium-base bearing lube (P/N
211337) through the plug hole until the gearcase is full.
Reinstall the boss adapter and grease plug.
Grease Plug
Plug Hole
Boss Adapter
— US-25 —

General Cleaning and Tightening

WARNING
POTENTIAL HAZARD
• When engine is running, cutting blade is
rotating and other parts are moving.
WHAT CAN HAPPEN
• Contact with rotating cutting blade or
other moving parts could cause serious
personal injur y or death.
HOW TO AVOID THE HAZARD
• Always turn off your Edger before you
clean or perform any maintenance on it.
The Maruyama Edger will provide maximum perfor-
mance for many, many hours if it is maintained proper-
ly. Good maintenance includes regular checking of all
fasteners for correct tightness, and cleaning the entire
machine.