Bus Mode Installation; Introduction; Terminal Wiring; Dip Switch Settings - RISCO Group WatchOUT eXtreme 315DT Guide D'installation

Introduction

The information in this section relates to WatchOUT 315DT installation in BUS Mode only. Up to
32 BUS detectors can be installed on the ProSYS RS485 BUS, saving cabling time and enabling
remote control and diagnostics.

Terminal Wiring

+,- Used for the connection of 12VDC power supply. Connect the (+) terminal to
the AUX RED and the (–) terminal to the COM BLK of the ProSYS terminals
YELLOW
Used for data communication with the ProSYS. Connect to the terminal to the
BUS YEL of the ProSYS
GREEN Used for data communication with the ProSYS. Connect to the terminal to the
BUS GRN of the ProSYS
TAMPER
Used for the wiring for tamper detection, see below
LED Used for the wiring for tamper detection, see below
ENABLE
Note:
All terminals that are not mentioned in the table above are unused.
Cover and Back Tamper
BUS Mode:
Cover + Back tamper wiring
ProSYS
Short
AUX COM
BUS
RED BLK YEL
GRN
TAMPER
FREE
+ - ALARM
YEL

DIP Switch Settings

DIP Switch Description
Number
1 - 5 Used to set the detector ID number. Set the ID number in the same way as for
any other ProSYS accessory (Refer to the ProSYS installation instruction
manual)
6 - 8 Not used

BUS Mode Installation

BACK
TAMPER (N.C)
FREE LEDs
AM
SET/
DUST TEST
UNSET
GREEN ENABLE
Cover Tamper to Zone Input
ProSYS
BUS
Zone
AUX COM
BUS
Z1
RED BLK
YEL GRN
TAMPER
FREE
+ - ALARM
YEL
WatchOUT 315DT Installation Manual
Cover Tamper Only
ProSYS
AUX COM
BUS
RED BLK
YEL GRN
TAMPER
FREE
+ - ALARM
YEL
Zone
BUS Mode:
Input Cover Tamper to Zone Input
COM Z2
Short
FREE AM LEDs
SET/
DUST TEST
UNSET
GREEN ENABLE
BUS Mode:
Cover Tamper Wiring
Short
FREE AM LEDs
SET/
DUST TEST
GREEN ENABLE UNSET
13